I first refered directly to the chapter 1-level paragraph style, but then got problems when a new chapter started on a right-page and not a left page, some picutures refered the previous chapter style. I then copied the chapter 1-paragraph style and made small text boxes with just the paragraph number on each page that starts a new chapter. I changed the text colour to no colour.
You can also insert a page number inside existing artistic or paragraph text. If the text is located on a local layer, the page number is inserted on the current page only. If the text is located on a master layer, the page number becomes part of the master layer and appears on all pages where the master layer is visible. For more information about artistic and paragraph text, see Adding and manipulating text.
I have installed MS 2007 home/studen on 2 computers in my home; a desktop and a laptop. The programs do not even have all the same fonts. The laptop has some fonts that the desktop doesn’t have and visa versa. Both systems are running Vista and both were installed with the same disk. I have also seen many occasions where the document comes through totally different.
I'm using Word 2016 (desktop) on a Windows 10 64-bit system, but this article applies to earlier versions. 365's browser edition displays numbered lists and offers a few basic settings. However, you can't apply either option discussed in this article using the browser. For your convenience, you can download the sample demonstration .docx or .doc file.
Let's say you want to use different page numbers or number formats and styles in different parts of your document. You could use page numbers such as i, ii, iii… for the introduction and table of contents and 1, 2, 3… for everything after. The trick is to divide the document into sections and to make sure those sections aren’t linked. Then, set the page numbering for each of those sections by following these steps.
Excellent stylus support (including the ability to adjust stylus tilt, bearing and rotation in real time). A quick editing workflow. Each node has a distinct appearance depending on the handle or selection type, and the size, colours and shapes of the editing points are customisable via Options. More intuitive interactive sliders for gradients, blends, transparency and so on wrap up a decent release.
I have read up on the InDesign figures and cross referencing and have been testing this out. I am using separate text boxes for each figure description with the jump frames command. When I delete a figure the numbers automatically update and I can update the cross references. However, when I add a figure the numbers go out of sequence and I can’t work out how to update them. Perhaps there is another setting I need to change? Is there a way of numbering text boxes sequentially? I was able to thread boxes to update the numbers but this could lead to problems down the line…Any advice on this would be greatly appreciated.

In Japanese, Chinese, or Korean versions, by default, Arabic numerals are used for page numbers. However, if you use the Numbering & Section Options command, you can specify the style of numbering, such as Roman numerals, Arabic numerals, Kanji, and so on. The Style option allows you to select the number of digits in the page number, for example, 001 or 0001. Each part of the document that uses a different numbering style is called a section. For more information on sections, see Define section numbering.
×